Skylight Replacement and Installation in Richmond Hill

New York Skylight Installers replaces, installs and supplies skylights in Queens houses, two families and rear extensions. Official VELUX dealer, LIC# 2084179, skylights only since 2005.

Richmond Hill is one of the great frame house neighborhoods of New York. Victorian and Queen Anne houses from the 1880s and 1890s on the older streets, long runs of 1920s brick and stucco either side of them, and a great many of the houses now carrying two families. What makes the roofs here worth talking about is that a lot of these houses do not have one roof, they have two.

The pattern is a pitched front slope, shingle or on the oldest houses slate, running back over the main body of the house, and then a flat or very low slope roof over the rear extension, the back bedrooms or a later addition. They meet somewhere along the middle of the house. That transition line is the single most important thing on the roof and it is where most of the water trouble on these houses starts, because it is the one place where two completely different roofing systems have to be joined and kept joined for decades.

It matters for skylights because a skylight is not one product here. A unit for the pitched slope is deck mounted with a manufacturer's step flashing kit woven into the shingle courses. A unit for the flat rear needs to sit up on a curb built proud of the surface so its flashing never stands in water. They are different units, different flashing, different prices and different failure modes, and a unit fitted as if the roof were the other kind is the most common reason a Richmond Hill skylight leaks. We have taken off plenty of pitched roof units that were sitting flat on a rear roof with sealant doing the whole job.

So the first thing we establish on the visit is which roof your skylight is actually on and whether what is on it belongs there. If there is a unit near the transition line we look hard at that junction as well, because water getting in at the step down will run under the flat roof and come out at the first obstruction, which is very often the skylight curb. That reads as a skylight failure and is not one.

On price, a fixed replacement on a curb that is still sound is $2,287 installed and the $1,760 standard replacement labor is already in that figure, and it assumes the correct flashing kit for the roof it is going on. A fixed deck mount unit for a pitched slope starts at $897 and a roof window you can reach and open starts at $1,004, each with its flashing kit. A manual venting unit is $1,092 on the flat rear and $1,295 on the pitched front. A brand new opening cut and finished starts at $3,850. On the oldest slate roofed houses we lift the slate back and reset it rather than breaking it out, and that is said in the proposal rather than discovered on the day.

Leaking skylight in Richmond Hill? Start with a professional assessment from New York's original skylight specialists. Skylights are all we have done since 2005: licensed and insured (LIC# 2084179), VELUX Trained & Approved, an official VELUX dealer, 4.9 stars on Google, and a 10-Year No Leak Warranty on every unit we install. Roofers and handymen do skylights on the side; we are the specialists the roofers call. Water dripping from the skylight, a stain on the ceiling under it, a drip that only shows up in a heavy rain: none of that tells you what actually failed. We come out, find the real cause, and give you a straight answer and a price for the right fix, which is usually a new unit. Active leaks go to the front of the schedule. Read more about skylight repair in Queens.

Richmond Hill skylight questions

Our Richmond Hill house has a pitched roof at the front and a flat one at the back. Does that change the skylight?

It changes it completely. A unit for the pitched slope is deck mounted with a manufacturer's step flashing kit woven into the shingle courses. A unit for the flat rear sits up on a curb built proud of the surface so the flashing is never standing in water. Different unit, different flashing, different price, and fitting one as though it were the other is the commonest reason a skylight here leaks.

The leak only shows up near where the two roofs meet. Why?

Because that transition is where two different roofing systems are joined, and it is the hardest detail on the house to keep sound. Water getting in at that step down runs along under the flat roof and comes out at the first thing that stops it, which is very often the skylight curb a few feet away. It looks like a skylight failure from inside and it is not one.

Can a skylight made for a sloped roof be used on our flat rear roof?

Not properly. On a low slope roof water moves slowly and stands, so the unit has to be raised on a curb and flashed to it, and a deck mounted pitched roof unit laid flat relies on sealant to do a job sealant cannot do for long. If we take one of those off we will show you what was under it before the new one goes on.

We have an original slate roof. Will you have to take it off?

No. On the slate roofed houses here the slate around the opening gets lifted back carefully and reset once the unit and its flashing are in, rather than broken out and patched with something that does not match. It is slower and it is written into the proposal, so it is not a conversation that starts on the day.

Our house is a two family. Who signs for the skylight?

The owner. The roof and the stair shaft are common to the building rather than to one apartment, so a tenant does not authorize the work. What we do set out in the proposal is which parts of the house the crew passes through to reach the roof and roughly when, so the people living there are told in advance.

Do we need a permit or landmark approval in Richmond Hill?

Putting a new unit into an existing opening is normally maintenance and needs no Buildings permit. Cutting a new opening is structural and does, starting at $3,850. On landmarks the answer in Queens is settled by the address rather than the neighborhood, and parts of Richmond Hill sit inside a designated district while nearby streets do not, so we confirm it against your address before anything is ordered. Our NYC permits and landmark rules page covers it.

Skylights in nearby Queens neighborhoods

Kew Gardens · Forest Hills · Maspeth · Ridgewood

We cover every part of the borough. See skylights in Queens, our published prices, or NYC permits and landmark rules. Serving 11418 and 11419.

Recent skylight work

Six-skylight great room in a New York residence
Six-skylight great room in a New York residence
Twin flat-glass skylight banks over a brownstone extension
Twin flat-glass skylight banks over a brownstone extension
Flat-glass fixed skylight set on a rebuilt curb
Flat-glass fixed skylight set on a rebuilt curb

See more of our installations →